Thermo-well Inserting

IFT Thermo-well inserting is the installation of temperature sensing wells into existing systems without a shutdown. IFT can provide thermo-wells and/or install your thermo-wells without interruption of service. A number of thermo-well models are available for a wide range of temperature applications, pressures, and types of pipelines. Monitoring equipment available varies from basic on-line thermo-meters to high tech microprocessor temperature controllers.

 

A wide variety of thermo-wells can be installed into any type of pipeline. In this particular case, the pipeline is steel and the "Weldone" fitting is welded to the pipe. With non-weldable, pipe a bolt-on saddle may be supplied. The "Weldone" assembly has been welded to the pipeline and a temporary access valve has been installed and pressure tested. After testing the fitting and temporary valve, the hot tap can be made into the pipeline. After the drill is retracted above the valve, the valve is closed and the tapping machine is removed from the line.

 

The thermo-well is held by a hex socket that has an allen screw to retain the thermo-well. The housing containing the thermo-well is screwed onto the temporary access valve.

 

 

The valve is opened and the thermo-well is pushed past the valve and threaded into the inside thread of the "weldone" fitting.

 

 

When properly installed, the pressure is sealed off by the thermo-well and the temporary valve can be removed.

 

 

Thermowell Selections, Equipment and Temperature Sensing Wells
TYPE: TW5-260 BORE SIZE: .260 PROCESS CON.: 1/2",N.P.T. 7/8" Hex Nut MATERIALS: Brass, Carbon Steel, 304sst,316sst	TYPE: TW5-385 BORE SIZE: .385 PROCESS CON.: 1/2",N.P.T. 7/8" Hex Nut MATERIALS: Brass, Carbon Steel, 304sst,316sst	TYPE: TW5-510 BORE SIZE: .510 PROCESS CON.: 3/4", N.P.T. 1-1/8" Hex Nut MATERIALS: Brass, Carbon Steel, 304sst,316sst
Now the tempature sensor can be installed into the wall shaft.
Socket Fit Thermowell	Compression Fit Thermowell	Electrical Hookup Complete